§ 02 — The Trade

The trade sheet.

Every ticket below is priced flat where we can, hourly where honesty demands it. Written estimate before work starts — always.

  1. SG · 01
    Lead time · 3–5 days

    High-Efficiency Boilers

    Hydronic heat done right — from load calc to commissioning.

    Wall-hung and floor-standing condensing boilers, in-floor radiant, panel radiators and cast-iron replacements. We size for the actual heat loss of your home, not a rule of thumb.

    Kit
    • · Viessmann
    • · Navien
    • · IBC
    • · Rinnai
  2. SG · 02
    Lead time · Same day

    Hot Water Tank Replacement

    Same-day tank swaps. Gas, electric, or heat-pump ready.

    Standard 40/50 gal swaps completed in a single visit, permit pulled and old tank hauled away. Ask about the switch to a hybrid heat-pump water heater — CleanBC rebate eligible.

    Kit
    • · Bradford White
    • · Rheem
    • · John Wood
  3. SG · 03
    Lead time · 24–48 hr

    Furnace Repair & Install

    Diagnose first. Replace only when the math says so.

    Warm-air furnace service for every make sold in the Lower Mainland. Two-stage and modulating replacements matched to your ductwork, with a static pressure test on handover.

    Kit
    • · Lennox
    • · Carrier
    • · Trane
    • · Napoleon
  4. SG · 04
    Lead time · 1–2 days

    Gas Fitting

    Class B gas ticket. Every joint pressure-tested.

    Range and dryer conversions, BBQ and firepit lines, fireplace hookups and pool heaters. All work permitted through TSBC, leak-checked with a manometer before we leave.

    Kit
    • · CSA-certified components only
  5. SG · 05
    Lead time · Same day

    Leaks & Plumbing Repair

    Short notice, dry floor. That's the job.

    Burst copper, pinhole leaks, failing shut-offs and slab leaks. We show up prepared, isolate the failure, and put the house back together — trim included.

    Kit
    • · Copper · PEX-A · ProPress
  6. SG · 06
    Lead time · Scheduled

    Annual Maintenance

    Keep the pilot lit. Keep the warranty valid.

    Combustion analysis, clean & tune, condensate trap flush, expansion tank check, sacrificial anode inspection. One visit a year, documented for your files.

    Kit
    • · Testo 320 combustion analyser

Not sure which line item you need? Just call.